Double Work Zone Gas Filling Insulating Glass Line. LBXH3000CQ/3300CQ

Affiliated series:

Insulating Glass Production Line

Insulating Glass Machine

Service Hotline：+86-18560126606

Product Details

1. Adopted with density composite plate, strong and durable; non-free backing wheel, reduce wheel printing; wear-resistant drive wheel and spring device, reduce friction with glass, durable, step drive wheel convenient for large glass; variable frequency conversion drive motor, stable and efficient

2. it can identify LOW-E automatically and coated glass, and equipped with an alarm device if the glass was reversed.

3.The whole 02 section adopted with stainless steel box, which is very strong and durable.

4.The cleaning section is equipped with 4 motors, 3 pairs of brushes, soft and hard alternate, can wash low-e, brush and motor one by one corresponding, stable and efficient, the use of universal nozzle, can thoroughly clean without dead corners, equipped with water heating, to ensure effective cleaning in winter

5. The bottom of the box adopts double-layer hollow design to avoid water and improve the service life of the bearing

6. Connect the spray pipe and the intake pipe with stainless steel to prevent aging

7. There are three seals: upper and lower oil seal and waterproof cover to prevent water and glass dust from entering the bearing

8. The drying part adopts aluminum profile wind blade, and the air outlet is very uniform and dense, to ensure that each surface of the glass is effectively dried

9.Quipped with 15 kw fan, achieve high efficiency and bellows with sound absorbing device, reduce noise pollution

10.When the glass stays in the position of the wind knife, the tuyere will automatically close to prevent the wind knife printing.

11. It equipped with double motors, can save two pieces of glass, accelerate the photoelectric switch, improve production efficiency.

12.The servo synchronous pressing adopts ball bars to fully ensure the parallel pressing of the two plates. The function of pressing moment is equipped for the hollow glass of different sizes, and the pressure holding time can also be adjusted according to the size of the glass.

13.At the bottom of the inflatable structure, more efficient, inert gas utilization rate, follow the sponge body block, automatically identify glass length, height, according to the length of the glass opening quantity, do maximum gas saving, improve the efficiency of inflation, plate pressure using servo motor control, make the plate pressure running more smooth and accurate. Using three-layer plate pressure structure, with local fine tuning function, to prevent the plate pressure for a long time after use, the pressure is more smooth.

Parts Brand:

NO	Name	Brand
1	PLC	Panasonnic
2	Touch screen	Screen through
3	Frequency transformer	Siemens
4	Circuit breaker	Siemens
5	AC contactor	Siemens
6	Switching Mode Power Supply	Ming wei
7	Electric relay	OMRON
8	Magnetic valve	AirTAC
9	AUTONICS Sensor	Autonics
10	Pneumatic component	AirTAC

Parameters:

Maximum glass size	30006000mm 33007000mm	Minimum glass size	300*300mm
Single sheet glass thickness	3-28mm	Insulating glass thickness	80mm
Glass cleaning speed	2-15m/min	Capacity	80-120/h(Double glass)
Gas Filling Speed	2-10s/m²	Inflatable rate	85%
Voltage	3P 380V 50HZ	Air pressure	0.6-0.8Mpa
Total power of equipment	68kw/76kw	Outline dimension	1950016003100